Fertilizer dilution calculator

The label gives a dose for a set amount of water, but you’re mixing a different amount. Copy the dose from the label, enter your water, and get the product to add.

Dose measured in

ml for a dose measured by volume, g for one that’s weighed. Switching clears the dose, as the two aren’t converted.

The label says

Doses given as a percentage, in ppm, in caps or spoons, or as a ratio such as 1:100 aren’t supported yet.

I’m mixing with

How it’s worked out

Product to add = label dose × water you’ll use ÷ label’s water.

The result is in the dose’s unit, ml or g. The two are never converted, since a milliliter of product rarely weighs exactly a gram.

The water you enter is the water you use, not the exact volume of the solution once the product is in.

Results are shown to three decimals. They aren’t rounded to spoons or caps, and the strength is never changed.

Worked example

5 ml per 1 L, mixing 1.5 L of water: 5 × 1.5 ÷ 1 = 7.5 ml.

4 g per 5 L, mixing 2 L: 4 × 2 ÷ 5 = 1.6 g.

2.5 ml per 1 L, mixing 0.75 L: 2.5 × 0.75 ÷ 1 = 1.875 ml.

Questions

My label gives a ratio such as 1:100. Can I use it?

Not in this version. The calculator needs the dose as an amount of product, in ml or g, for an amount of water in liters. Percentages, ppm, caps and spoons aren’t supported either.

Why can’t I convert between ml and g?

A milliliter of product only weighs a gram if it’s as dense as water, and most aren’t. Choose the unit the label uses. Switching units clears the dose so you can enter it again.

Does it tell me how often to feed my plants?

No. It scales one dose to your water. Follow the label for how often to apply it and which plants it suits.

What if the amount is very small?

Amounts below 0.001 ml or g show as less than 0.001. For small doses, a syringe or a precision scale measures better than a spoon.