Plant spacing calculator

How many plants fit in this bed at the spacing you’ve chosen? Enter the bed’s inside length and width and the spacing, and see the count and a drawing of the grid.

Units

Replaces what you’ve entered.

Bed

Spacing is measured from the center of one plant to the next. Edge clearance is measured from a plant’s center to the bed’s edge.

  1. Length
  2. Width
  3. Spacing
  4. Row spacing
  5. Clearance

Inside the edging. Rows run along the length.

Inside the edging.

Spacing

Between plants in a row.

Edge clearance: half the spacing, at the ends and at the sides.

How it’s worked out

Plants go in straight rows along the bed’s length, on a grid. Spacing is measured from the center of one plant to the next.

Plants per row = the length minus the clearance at both ends, ÷ the spacing, rounded down, + 1. Rows are worked out the same way across the width, with the row spacing and the clearance at the sides.

Positions = plants per row × rows. The grid is then centered in the bed, so the clearance you end up with can be a little more than the minimum.

By default, the clearance is half the spacing: half the plant spacing at the ends, half the row spacing at the sides. You can set your own; 0 puts plant centers on the bed’s edge.

It doesn’t divide the area by the spacing squared, which can count plants that don’t fit at the edges. The grid isn’t rotated or staggered.

Worked example

A 10 ft × 4 ft bed, with plants and rows 12 in apart, and the automatic 6 in clearance.

Along the length: (120 − 2 × 6) ÷ 12 = 9, + 1 = 10 plants per row. Across the width: (48 − 2 × 6) ÷ 12 = 3, + 1 = 4 rows. 10 × 4 = 40 positions, 6 in from every edge.

Questions

Where does the spacing come from?

From you: the plant label, a seed packet or advice you already have. The calculator lays out the grid; it doesn’t know which plants you’re growing.

Why are there no plants right at the edge?

By default each plant’s center is kept half a spacing from the edge. Turn on custom clearance to change that; a clearance of 0 puts centers on the edge and can fit more.

Do the dots show how big the plants will grow?

No. They mark where each plant’s center goes. Grown size depends on the plant, which the calculator doesn’t know.

Can it suggest a spacing, or stagger the rows?

Not in this version. It has no list of plants and uses straight rows only; staggered rows, paths and irregular shapes aren’t supported.